Team Losi LOS-A0951 Owner's Manual page 38

ENGINE INSTALLATION (Continued)
Fig 77.
Step 39. Cut a 3" length of fuel tubing (166) from the
remaining section.
*NOTE: If there are two types of fuel tubing supplied with
your kit use the transparent piece. This piece should already
be cut to 3".
Step 40. Cut two 1 /16"- 1 /8" lengths of 3/8" silicone tub-
ing (164) off of the remaining section. Place these two pieces
over the piece of fuel tubing as shown. These will be used
later to hold your radio system wires in place.
Fig 78.
Step 41. Attach one end of the fuel tubing (166) to the
rear fitting on the top of the fuel tank (38), and attach the other
end to the fitting on the carburetor.
Figure
77
Figure 78
35