Team Losi LOS-A0951 Owner's Manual page 37

ENGINE INSTALLATION (Continued)
Fig 75.
Step 34. Rotate the tuned pipe (161) so that the stinger
points down slightly. Secure the tuned pipe (161) to the header
by installing an 8" tie strap (181) around the header (160), and
the pipe (161), and tightening.
Step 35. Secure the header (160) to the manifold (159)
by installing an 8" tie strap (181) around the header (160), and
the manifold (159), and tightening. Cut off the extra length from
both tie straps (181).
Fig 76.
Step 36. Cut a 7" length of fuel tubing (166) from the
piece supplied.
*NOTE: Some kits may come with two types of fuel tub-
ing. For this step use the opaque (non-transparent) fuel tub-
ing.
Step 37. Cut one end of the 7" piece of tubing at a 45°
angle as shown in figure 76A. Install the uncut side of the tub-
ing to the forward fitting on the top of the fuel tank (38).
Step 38. Route the tubing to the right of the center chas-
sis brace (37), under the stiffener, and behind the rear steering
servo post (40), as shown. Insert the cut end of the tubing into
the inside (small) hole in the tuned pipe (161).
&
IMPORTANT NOTE: Make sure that the cut sec-
tion of fuel tubing is inserted all the way into the tuned pipe.
Figure 75
Figure 76
Figure 76A
34