Antenna Alignment; Table 7-9 Transmitter Status Checks - Motorola PTP 800 User Manual

Installing the link
Go to the Status page, or use the Installation Wizard and navigate to Step 6:
Antenna Alignment. Check the Transmitter Status attribute and take action as
described in

Table 7-9 Transmitter Status checks

Transmitter Status
Transmitting
Muted – By User
Muted – ODU Configuring
Muted – ODU Fault
Muted – Configuration Error

Antenna alignment

Repeat the Antenna Alignment procedure as described
on page 5-102.
Check the receive power from the RSSI connector of the ODU, or from the Receive
Power attribute in Step 6: Antenna Alignment.
If the receive power level is very small or cannot be measured, continue at
transmit and receive frequencies
If the receive power is close to the predicted power for the link then continue at
Check link status
7-10
Table 7-9.
attribute
on page 7-11.
Continue at Antenna alignment
The Antenna Alignment step of the Install Wizard
has not been completed successfully, or the
transmitter has been muted using the Mute
Transmitter button on the Configuration Page.
Restart the Installation Wizard.
Transmission is disabled while the ODU
configuration is changing. This status will
normally exist for no more than a few seconds.
There is a fault in the ODU. Use the Home page
to review the ODU alarms.
The ODU is not compatible with the configured
radio license. Restart the Installation Wizard.
on page 7-11.
Chapter 7 Troubleshooting
Action
on page 7-10.
Step 6: Aligning antennas
phn-1478_005v000
Check
Apr 2010