Table of Contents
Advertisement
Chapter 5 Installation
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
This chapter describes how to install a PTP 800 link. It describes hardware
installation, powering up, initial configuration, antenna alignment and network
connection. This chapter is arranged as follows:
x
Inventory and tools
that are required for installing a PTP 800 site.
x
Cable connection procedures
procedures that may be performed repeatedly in the course of site
installation.
x
Direct mounting of antenna and ODU
how to mount the antenna and ODU directly together on the mast.
x
Remote mounting of antenna and ODU
how to mount the antenna and ODU separately on the mast.
x
Installing the IF and ground cables
to install the IF cables and how to install grounding and lightning protection.
x
Installing the CMU
connect the CMU.
x
Testing the installation
site installation.
x
Connecting the CMU to a PC or workstation
describes how to connect a PC to the CMU to allow the web management
interface to be used.
x
Installation wizard
seven installation wizard steps using the web management interface.
x
Connecting the CMU to the network
typical configuration tasks that must be completed in order to prepare the
CMU for network operation.
x
Alternative approaches
approaches to allow the tasks to be completed in a different order.
phn-1478_005v000
Apr 2010
on page 5-3: This section lists the components and tools
on page 5-13: This section describes three
on page 5-28: This section describes
on page 5-58: This section describes how
on page 5-70: This section describes how to install and
on page 5-77: This section describes how to test the
on page
5-91:
This section describes how to execute the
on page
on page 5-113: This section describes some alternative
on page 5-39: This section describes
on page 5-87: This section
5-109:
This section describes
Chapter 5
. .
.
.
.
.
5-1
Advertisement
Table of Contents
