User Guide: PTP 800 Licensed Ethernet Microwave
Configuring the wireless interface
Enabling wireless transmission
Perform this task to enable the unit after installation or configuration
To enable wireless transmission, proceed as follows:
Procedure 6-2 Enable wireless transmission
From the left hand menu, select Configuration. The System Configuration
1
page is displayed. Check that the Transmitter attribute value is 'Muted'
(Figure
2
Select Enable Transmitter. This permits the antenna to radiate. The
Transmitter attribute value changes to 'Enabled'
Figure 6-6 System Configuration page (partial view) when transmitter is muted
Disabling wireless transmission
Perform this task to mute transmission, for example when maintenance work is
needed near the antenna.
To disable wireless transmission, proceed as follows:
Procedure 6-3 Disable wireless transmission
From the left hand menu, select Configuration. The System Configuration
1
page is displayed. Check that the Transmitter attribute value is 'Enabled'
(Figure
Select Mute Transmitter. The Transmitter attribute value changes to
2
'Muted'
phn-1478_005v000
Apr 2010
6-6).
6-7).
(Figure
6-6).
Configuring the wireless interface
(Figure
6-7).
6-11