Table of Contents
Advertisement
Configuring the IP and Ethernet interfaces
Configuring the IP and Ethernet interfaces
Configuring the IP interface and management mode
Perform this task to review and update the IP interface settings of an operational or
newly installed PTP 800 link.
The IP interface allows users to connect to the PTP 800 web interface, either from a
locally connected computer or from a management network.
CAUTION
To configure the IP interface, proceed as follows:
Procedure 6-7 Configure IP interface
1
From the left hand menu, select Configuration, LAN Configuration. The
LAN Configuration page is displayed
Review and update the IP interface attributes
2
3
If any attributes have been updated, select Submit Updated System
Configuration.
If Management Mode is set to 'Out-of-Band Local' or 'Out-of-Band', configure
4
the management port as described in
6-24, and connect the CMU to the management network or local
management computer via the management port.
If there is a requirement to reboot the CMU in order to implement the
5
updated attributes, perform
6-18
Before setting Management Mode to 'Out-of-Band' or 'In-Band', ensure
that the local and remote CMUs are configured with different IP
addresses, otherwise the management agent will not be able to
distinguish the two CMUs.
(Figure 6-9
(Table
Configuring the Ethernet ports
Rebooting the CMU
Chapter 6 Operation
or
Figure
6-10).
6-10).
on page 6-51.
phn-1478_005v000
Apr 2010
on page
Advertisement
Table of Contents
