Table of Contents
Advertisement
User Guide: PTP 800 Licensed Ethernet Microwave
Capacity, transmit power and sensitivity
This section contains tables that specify, for each frequency band, region (FCC and
ETSI), bandwidth and modulation mode, the following data:
x
'Capacity' refers to the maximum sustained aggregate load (Mbit/s) applied to
the data and management Ethernet ports that can be delivered to the remote
Ethernet ports without packet discard.
x
'Fixed/ref' refers to the availability of the modulation mode as a fixed or
reference mode.
x
'Sensitivity' refers to the typical receive signal level which produces a Frame
Error Rate of 5 x 10
Rate of 1 x 10
x
'Max tx Power' refers to the maximum value to which the Maximum Transmit
Power parameter may be configured. The PTP 800 will not transmit at a level
greater than the configured value of Maximum Transmit Power. However if
ATPC is enabled, the PTP 800 may transmit at a lower power than the
configured value for Maximum Transmit Power.
x
'Min tx Power' refers to the minimum value to which the Maximum Transmit
Power parameter may be configured. If ATPC is enabled, the PTP 800 may
transmit at a lower power than the configured value for Minimum Transmit
Power.
The tables are ordered by frequency band and region as follows:
x
Capacity, transmit power and sensitivity – Lower 6 GHz FCC
x
Capacity, transmit power and sensitivity – Lower 6 GHz ETSI
x
Capacity, transmit power and sensitivity – 7 GHz ETSI
x
Capacity, transmit power and sensitivity - 11 GHz FCC
x
Capacity, transmit power and sensitivity - 11 GHz ETSI
x
Capacity, transmit power and sensitivity - 18 GHz FCC
x
Capacity, transmit power and sensitivity - 18 GHz ETSI
x
Capacity, transmit power and sensitivity - 18 GHz Brazil
x
Capacity, transmit power and sensitivity - 23 GHz FCC
x
Capacity, transmit power and sensitivity - 23 GHz ETSI
x
Capacity, transmit power and sensitivity - 26 GHz ETSI
x
Capacity, transmit power and sensitivity - 38 GHz ETSI
phn-1478_005v000
Apr 2010
-4
using 64 octet frames. This is equivalent to a Bit Error
-6
as defined in EN 302 217 Annex F.
Wireless operation
on page
4-40
on page
4-41
on page
4-41
on page
4-43
on page
4-44
on page
4-45
on page
4-47
on page
4-49
on page
4-51
on page
4-53
on page
4-55
on page
4-57
4-39
Advertisement
Table of Contents
