Step 4: Confirming Installation Configuration; Table 5-8 Step 3: Wireless Configuration Attributes - Motorola PTP 800 User Manual

User Guide: PTP 800 Licensed Ethernet Microwave

Table 5-8 Step 3: Wireless Configuration attributes

Attribute
Maximum Transmit
Power
User ACM Highest
Mod Mode
User ACM Lowest
Mod Mode

Step 4: Confirming installation configuration

Perform this task to confirm that the parameters have been correctly set in steps 1
to 3 of the installation wizard.
To confirm the configuration, proceed as follows:
Procedure 5-22 Confirm installation configuration
1 The Step 4: Confirm Installation Configuration page is displayed
5-35).
2 Review the attributes. If any are incorrect, select Back and return to the
appropriate step to correct them.
3 If all attributes are correct, select Submit Updated Installation
Configuration. If the configuration is unchanged, the Submit button is
replaced by Next.
phn-1478_005v000
Apr 2010
Enter the maximum transmit power the wireless unit is
permitted to use when establishing and maintaining the
wireless link. This defaults to the lowest of the maximum
allowed by the equipment, the maximum allowed by the
license or the user maximum set in a previous
installation.
This is the maximum modulation mode the radio can use
when ACM is enabled. The valid range depends on the
region, license and Tx Max Power. This attribute is
only visible for certain regions when Radio
License Modulation Selection is set to 'Adaptive'.
This is the minimum modulation mode the radio can use
when ACM is enabled. The valid range depends on the
region, license and Tx Max Power. This attribute is
only visible for certain regions when Radio
License Modulation Selection is set to 'Adaptive'.
Installation wizard
Meaning
(Figure
5-99