Cable Connection Procedures; Preparing If Cables - Motorola PTP 800 User Manual

User Guide: PTP 800 Licensed Ethernet Microwave

Cable connection procedures

This section describes three procedures that may be performed repeatedly in the
course of site installation:
x

Preparing IF cables

x
Waterproofing connectors
x
Installing the cable grounding kit
Preparing IF cables
The crimp tool for the standard N type connectors is available from Motorola, see
Table 5-3.
NOTE
To crimp connectors to IF cables, follow the manufacturer's instructions
summarized below.
Procedure 5-1 Prepare IF cables
Check that the correct IF cable crimp tool and connectors are available.
1
2 Remove 21mm (0.827 inch) of the outer jacket:
phn-1478_005v000
Apr 2010
on page 5-13.
Not all connectors and crimp tools are compatible. If any other type of
connector is to be installed, ensure that the correct crimp tool is used.
on page 5-17.
on page 5-20.
Cable connection procedures
5-13