Table of Contents
Advertisement
Configuring the wireless interface
Configuring quality of service
Perform this task to to configure the classification of Layer 2 Control Protocol
frames and priority encoded Ethernet frames into up to eight traffic classes.
To configure quality of service, proceed as follows:
Procedure 6-6 Configure quality of service
1
From the left hand menu, select Configuration, Bridge Configuration. The
Bridge Configuration page is displayed
Review and update the quality of service attributes
2
3
To use IEEE 802.1Q classification rules, select Set Default 802.1Q Priority
Mappings.
If any attributes have been updated, select Submit Updated Values.
4
Figure 6-8 Bridge Configuration page
6-16
(Figure
6-8).
(Table
6-9).
phn-1478_005v000
Chapter 6 Operation
Apr 2010
Advertisement
Table of Contents
