Table of Contents
Advertisement
User Guide: PTP 800 Licensed Ethernet Microwave
Connecting the CMU to a PC or workstation
By default, the IP interface of the CMU is configured for out-of-band local
management with an IP address of 169.254.1.1, subnet mask of 255.255.0.0 and
default gateway of 169.254.0.0. If the IP interface has been pre-configured (as
described in
procedure described below to align with the current interface configuration.
The procedure is based on the Windows XP™ operating system. Adapt the
procedure as necessary for other operating systems.
Configure the IP interface on the PC
Perform this task to set up the IP configuration of an unused Ethernet port on a PC
using the Network Connections icon in the Control Panel.
In case of difficulty, review troubleshooting guide at
management interface
To configure the IP interface, proceed as follows:
Procedure 5-17 Configure the IP interface on the PC
1
2
3
4
5
phn-1478_005v000
Apr 2010
Connecting the CMU to the network
on page 7-2.
Select Properties for the Ethernet port.
Select the Internet Protocol (TCP/IP) item as shown in
Click on Properties.
Enter an IP address that is valid for the 169.254.X.X network, avoiding
169.254.0.0 and 169.254.1.1. The interface in
with an IP address of 169.254.1.3.
Enter a subnet mask of 255.255.0.0.
The default gateway can be left blank.
Connecting the CMU to a PC or workstation
on page 5-109) then adapt the
Connecting to the web
Figure
Figure 5-26
5-25.
is configured
5-87
Advertisement
Table of Contents
