Table of Contents
Advertisement
User Guide: PTP 800 Licensed Ethernet Microwave
7
Apply silicone grease to the 'O' Ring of the antenna transition.
8
When fitting the coupler to the antenna, the following fitting sequence
must be followed:
phn-1478_005v000
Apr 2010
x
Initially, hand-tighten two of the diagonally opposed M8 bolts
with the Allen key supplied in the kit.
x
Using the latch clamp, clip the same two corners.
x
Repeat the above on the remaining two diagonally opposed
bolts and clips.
x
Torque down all four M8 bolts to 18 Nm.
Direct mounting of antenna and ODU
5-35
Advertisement
Table of Contents
