Table of Contents
Advertisement
Remote mounting of antenna and ODU
Remove the protective film from the coupler remote mount port.
6
Apply silicone grease to the 'O' ring of the remote mount transition.
7
8
When fitting the coupler to the remote mount, the following fitting
sequence must be followed:
5-54
x
Initially, hand tighten two of the diagonally opposed M8 bolts
with the Allen Key supplied in the kit.
x
Using the latch clamp, clip the same two corners.
x
Repeat the above on the remaining two diagonally opposed
bolts and clips.
x
Torque down all four M8 bolts to 18Nm.
Chapter 5 Installation
phn-1478_005v000
Apr 2010
Advertisement
Table of Contents
