Factory Five Racing Gen 3 Type 65 Coupe Owner's Manual page 51

Using a marker trace along each tube on the aluminum panels where they contact the chassis. If you see a spot
where a drill or rivet cannot be installed due to lack of space or interference then make a small note not to drill
in that area. This is done to locate where to drill rivet holes when the panels are permanently mounted later on.
Mark each panel and take pictures of how the panels fit together (i.e. which is on top).
Remove each panel after it has been marked until the chassis is bare. Keep the #8 screws to help with the
aluminum positioning later during build-up.
50
www.factoryfive.com 508-291-3443