Factory Five Racing Gen 3 Type 65 Coupe Owner's Manual page 541


In some cases not all parts listed below will be necessary, but it is suggested to obtain all
parts to avoid future difficulties.
PART NAME
Engine
Engine mount, (L,R) w/nuts and bolts
Starter
Transmission, bell-housing, clutch, and shifter components
Transmission mount w/nuts and bolts
Driveshaft w/4 bolts
Clutch cable w/bell-housing retaining c-clip
Speedometer speed sensor w/plastic gear
Mass air sensor with flexible elbow
Oxygen sensors
Exhaust
Exhaust headers w/nuts and bolts
Cooling Heater hoses to firewall w/clamps
Fuel tank w/plastic under tray, gas cap, and mounting straps
Filler neck
Fuel filter w/mounting bracket and hoses
High pressure fuel line, tank to filter
Low pressure return line to fuel tank
High and low pressure solid fuel lines attached to engine fuel rails
Fuel evaporative canister, solenoid and tubing
Front and rear brake rotor/drum, calipers, pads, flexible lines, etc.
Mount front and rear brake line, riveted to donor
Front and rear wheels with lug nuts
Spindles, front
Rear upper control arms w/nuts and bolts
Rear lower control arms w/nuts and bolts
8.8inch complete rear axle assembly
Front lower A-arms w/nuts and bolts
Power steering lines if using power steering
Steering rack with mounting bushings
Inner and outer tie-rod ends (87-93 applications only)
Wiring harness (all)
Emergency inertia cut-off switch
Turn signal stalk, and ignition cylinder w/key from steering column
Horns
Battery w/ground cable
Coil, starter solenoid
EEC IV Computer w/holder
540
www.factoryfive.com 508-291-3443
CHECK