Table of Contents
Advertisement
Computer ground near driver's foot box
Ignition and Turn signal stalk
" socket,
5
Hack saw,
/
16
Misc. Electrical Components, Mustang ignition switch and turn signal stalk.
The turn signal stalk can be cut shorter so that when it's mounted it will not protrude past the dash lip.
If you want to cut the stalk length, do it after the dash is installed and you have sat in the car to see if it
is needed. Cut half of the length first. Do not worry about the pieces that fall out, they are for the
Mustang wipers and are not used. Re-use the end cap and epoxy glue it to the newly cut stalk to give it a
nice finished look.
Sit in the car and mount the turn signal stalk with the stalk pointed towards the seat as high as possible on the
1.50" square tube going across the car so that your knee or leg does not hit it. Use two #10 x 1" screws and a
" socket and
" drill bit.
5
9
/
/
16
64
The ignition switch mounts near the turn signal stalk on the 1.50" tube. Mount the switch to the outside of the
turn signal so that they do not hit each other when the turn signal is operated. Use two #14 x 1.50" screws and a
" socket and
" drill bit.
5
9
/
/
16
64
Brake light and Clutch switches
A clutch safety switch is used to prevent starting the car while in gear. It requires pushing the clutch
pedal in while starting the car.
Another clutch switch option is to use a momentary dash switch that must be used at the same time as
the key.
If a switch is not going to be used, connect the two wires together by either soldering the wires or using a butt
connector from the "misc. electrical components" assembly in the Factory Five main kit pack.
" drill bits, drill.
9
/
64
www.factoryfive.com
280
508-291-3443
Advertisement
Table of Contents
