Rear Harness - Factory Five Racing Gen 3 Type 65 Coupe Owner's Manual

Rear Harness

Run rear harness from the driver foot box inside wall, along inside the transmission tunnel straight back to the
rear of the frame. Use zip ties, insulated line clips, and the wire loom to hold the wires and battery cable.
At the rear of the frame, run the wires low on the frame so that they are accessible after the body is mounted to
the frame. Run the brake light wires to the far corners of the frame.
Locate the inertia cut-off switch out of the way but still accessible in case it is tripped. Use the switch as a
template and drill two holes in the trunk aluminum on the far corner of the left side then mount with the
provided screws.
Run (2) wires (using the blue wire extensions in the misc. electrical components) from the left rear, side marker
light, to the center to be used for the license plate light. Leave the wires in the center for now.
Run the harness forward to the beginning of the left foot box, passing over the transmission harness section on
the way.
" holes about a ¼" apart and
3
Cable ties can be used to secure the harness up to the hole by drilling two /
16
passing a zip tie through it.
At the front of the tunnel, the rear harness goes up into the top foot box area where it meets the dash/engine
main harness.
274
www.factoryfive.com 508-291-3443