Watermark Adjustment For Density Compensation; Adjusting The Color Balance (Density); Adjusting The Color Balance - Intec CS4000 User Manual

Matching colors using the control panel
Watermark adjustment for
density compensation
1
You can adjust the watermarks for the density
based on the density compensation.
Adjust each color separately for the parts where
the density is a nuisance from the print results.
2
This section explains the procedure for adjusting
the cyan watermarks. Use the same adjustment
procedure also for other colors that you wish to
adjust.
3
z Increasing cyan after checking the print results
1
Press the [Fn] key.
The numerical values input screen will
be displayed.
4
5
2
Press [3], [1], [0], and press the [OK]
button.
Memo
z The procedures for adjusting magenta, yellow, and
black are described below.
– To adjust magenta, press the [Fn] key, [3], [1],
[1], and [OK] buttons.
– To adjust yellow, press the [Fn] key, [3], [1], [2],
and [OK] buttons.
– To adjust black, press the [Fn] key, [3], [1], [3],
and [OK] buttons.
3
Specify a larger value than the current
value, and press the [OK] button.
Memo
z To increase the density, select +1 to +3, and to
decrease the density select -1 to -3.
4
Press the [ON LINE] button to return to
the standby screen.
5
Press the [Fn] key, [3], [0], [0], and
press the [OK] button.
6
Check that [Execute] has been selected,
and press the [OK] button.
- 106 -
7
The display will return to the standby
screen.
8
Printing will be implemented.
If the density is still incorrect, repeat steps
1 to 6.
Matching colors using the control panel

Adjusting the color balance

(density)
The printer can implement compensation
periodically using auto density compensation
mode, but implement this adjustment to adjust
the color balance in the intervals where auto
density compensation is insufficient.
Note
z The densities of each color are mutually dependent, so it
is necessary to repeat the adjustments several times until
the correct color balance is reached.
z The results of the basic [Base Color Tuning] are reflected
in the settings in [Fine Color Tuning]. Consequently, if the
[Fine Color Tuning] are adjusted manually, these settings
will be reset, so be careful. The [Black Tuning] settings,
however, are not reset.
z Printing is disabled if [Local print] in the (optional) print
job accounting is set to [Disable printing] or [Disable color
printing].
1
Printing color matching patterns.
(1)
Press the [Fn] key.
The numerical values input screen
will be displayed.
(2)
Press [3], [0], [2], and press the
[OK] button.
- 107 -
1
2
3
4
5