End Point Adjustment - FUTABA 7PX User Manual

Home screen
Steering end point adjustment
(Preparation)
- Before setup of the steering end point adjustment, set the steer-
ing D/R dial (initial setup: DT5) to the maximum steering angle
position 100%.
- Tap the travel button of the [Steering Left]. Value input buttons
appear on the screen and make the following adjustments:
1
Steering (left side) adjustment
Turn the steering wheel fully to the left and use the [+]
or [-] buttons to adjust the steering angle.
2
Steering (right side) adjustment
Turn the steering wheel fully to the right and use
the [+] or [-] buttons to adjust the steering angle.
Note
Step #1 & #2 are done when the receiver is in the on position installed on
the chassis. You're watching the wheels reach their maximum end point.
3
When fi nished, return to the Linkage menu screen by press-
ing the HOME button.
Steering left side adjustment
With the steer ing wheel
turned fully to the left, steer-
ing is adjusted by steering
trim. Temporarily displayed
at this par t of the HOME
screen as shown in the fi g-
ure below.
56
1M23N32602_7PX_E.indb 56
Menu screen
Menu-1
Quick EPA
When EPA trim is turned on, the steering angle (end point) can be adjusted
by steering trim set digital trim or dial. (Steering trim initial setting: DT1)
L
End Point
Linkage menu
Menu-2
For S-FHSS (analog) system,
5 to 7 channels are displayed
on the 2nd page.
Adjustment buttons
- Return to the initial value by
Steering End point :0~140
DT1
R
Channel Reverse
Tap to change page.
Adjust with the [+] and [-] but-
tons.
tapping the [reset] buttons.
Initial value :100
Steering right side adjustment
With the steer ing wheel
tur ned fully to the right,
s t e e r i n g i s a d j u s t e d by
steering trim. Temporarily
displayed at this part of the
HOME screen as shown in
the fi gure below.
2017/08/02 14:17:17