FUTABA 7PX User Manual page 116

2
(Channel setup)
The channel list screen used for the front ESC channel is displayed. Tap the auxiliary chan-
nel that connected the front ESC channel.
- When all channels are in use, a screen saying "No assignable channel" is displayed, please turn off other mixing
and make an unused channel. You can check the mixing used on the channel setting screen (page 75).
3
(Drive ratio adjustment)
Adjust the front and rear motor controller
operation amount by
button increases and the
creases the rear ratio.
Both the front and rear ratios become
100%
4
(Mix mode setting)
Tap "MIX mode" (ON) or (OFF) to select ON / OFF.
"OFF" :The EXP function of the 2nd CH and other settings are not mixed.
"ON" :The EXP function of the 2nd CH and other settings are mixed.
5
(Trim mode setup)
Tap "Trim mode" (ON) or (OFF) to select ON / OFF.
"OFF" :The trim of the 2nd CH is not mixed.
"ON" :The trim of the 2nd CH is mixed.
6
When fi nished, return to the Mixing menu screen by pressing the HOME button twice.
Dial / Trim Setting
The dial select function can control the drive ratio with digital dial or digital trim.(page 66)
Note:
As this function drives 2 separate motor controllers simultaneously, a mutual load is ap-
plied. Use this function carefully so that the motor controllers are not damaged.
Futaba will not be responsible for motor controller, motor, and other vehicle trouble due
to use of this function.
1M23N32602_7PX_E.indb 117
For S-FHSS (analog)
system, 1 to 7 chan-
nels are displayed.
or button. The
button de-
Dual ESC
If there is no assignable
channel, tap [Close]. Turn
off other mixing and make
assignable channels.
Adjustment buttons
- Adjust with the and buttons.
- Return to the initial value by
tapping the [reset] buttons.
Rear rate (Rear mix rate)
0~100
Initial value:100
Setting
- Tap (ON) / (OFF).
Setting
- Tap (ON) / (OFF).
2017/08/02
117
14:17:32