FUTABA 7PX User Manual page 95

- Delay
Set the delay from when the throttle is operated until when the traction control operation
starts. When set to 0%, the traction control function works without delay. At 50%, the trac-
tion control function works approximately 0.5 second later, and the traction control function
works about 1.0 second later at 100%.
- Cycle speed
Sets the pulse speed (cycle speed). The smaller the set value, the faster the pulse cycle.
- Duty ratio
Set the ratio of the time to operate to the high side and the time to operate to the slow side
in the pumping operation.
The ratio can be set to +4 ~ +0 ~ -4 in 9 steps.
- Trigger point
In the throttle operation, set the position of the trigger at which traction control starts to
work. Normal / Reverse, reverse the throttle operation range where the traction control op-
erates, with the trigger point as the boundary.
Traction control function adjustment
1
(Function ON/OFF)
Tap "Mixing" (ON) or (OFF) to select ON /
OFF.
"OFF" :Traction control function OFF
"ON" :Traction control function ON
When using Traction control function ON/
OFF by switch, use the switch select func-
tion (page 69) to set the switch to be used.
2
("Throttle return" amount adjustment)
Tap the value button of the [Brake return]. Value input buttons
appear on the screen. Use the [+] and [-] buttons to adjust
the return amount.
"0" :No return
"50" :Return to the 50% position of the brake operation amount
"100" :Return to the neutral position.
96
1M23N32602_7PX_E.indb 96
Throttle return
Throttle return
(Amount of throttle return)
Traction control
* Displays ON/OFF of the condi-
tion that Traction control is work-
ing by throttle trigger operation.
Adjustment buttons
- Adjust with the [+] and [-] but-
tons.
- Return to the initial value by
tapping the [reset] buttons.
Return amount
0 ~ 50 ~ 100
Initial value: 50
The amount of throttle return
varies depending on the curve
setting of the throttle etc.
2017/08/02 14:17:28