FUTABA 7PX User Manual page 24

Installing the accessory APA steering wheel offset adapter
- Obtain 2.5mm hex wrench./ Remove the battery.
- The length of the screws used at each part differs. When reassembling the steering wheel unit, always use the
specifi ed screws.
1
Remove the 2 steering wheel unit mount-
ing screws (3.0x12mm cap screw)
(Using a 2.5 mm hex wrench.)
Remove the 2 mounting screws completely from
the transmitter body.
2
Gently remove the steering unit, without
pulling excessively on the wiring.
- Since there are claws on the top and bottom of the
steering unit, please do not pull straight out force-
fully.
- Please slowly remove in the order of 1 3 in the
right fi gure.
- Remove the steering unit slowly so that the inter-
nal wiring is not pulled unreasonably.
3
Remove the 3 connectors from the PC
board.
Press the upper side of the connector to release
the lock and remove it from the PC board.
(The 3 connectors each have the same lock type
although they are different in size.)
4
Using a Phillips screwdriver, remove the 4 screws (2.6x15mm tapping screw) mounting the
wheel unit and switch unit.
1M23N32602_7PX_E.indb 25
Unit mounting screws
Steering wheel unit
1
3
Press to unlock
Wheel unit Switch unit
2
25
2017/08/02 14:17:03