Table of Contents
Advertisement
This menu registers the telemetry sensors used with the transmitter. When only one of a
certain type of sensor is used, this setting is unnecessary and the sensor can be used by
simply connecting it to the S.BUS2 port of the transmitter.
When using 2 or more of the same kind of sensor, they must be registered here.
What is a slot?
Servos are classifi ed by CH, but sensors are classifi ed in units called " slot " . There are
slots from No. 1 to No. 31. Using a sensor which uses two or more slots, the required
number of slots is automatically assigned by setting up a start slot. When 2 or more of
the same kind of sensor are used, the sensors themselves must allocate unused slots and
memorize that slot.
Home screen
About the slots that can be used.
As shown in the table below, the current sensor requires three consecutive slots, and the GPS sensor requires 8
consecutive slots. The GPS sensor (SBS - 01 / 02G) has a starting slot of 8.16.24.
sensor
TEMP(SBS-01T)
RPM(SBS01RM)
Voltage(SBS-01V)
Current(SBS-01C)
GPS(SBS-01/02G)
162
1M23N32602_7PX_E.indb
162
Sensor List
Menu screen
Slot
State with registered sensor
Change to "---------", you can make it
an empty slot.
Slot number
The required number of
slots
1 slot
1 slot
2 slot
2 slot
8 slot
Sensor List
Telemetry menu screen
Sensor is not registered
in slot.
The number which can be used as a start slot
1~31
1~31
1 , 2 , 3 , 4 , 5 , 6 , 8 , 9 , 1 0 , 1 1 , 1 2 , 1 3 , 1 4 , 1 6 , 1 7 , 1 8 , 1 9 ,
2 0 , 2 1 , 2 2 , 2 4 , 2 5 , 2 6 , 2 7 , 2 8 , 2 9 , 3 0
1 , 2 , 3 , 4 , 5 , 6 , 8 , 9 , 1 0 , 1 1 , 1 2 , 1 3 , 1 6 , 1 7 , 1 8 , 1 9 , 2 0 ,
2 1 , 2 4 , 2 5 , 2 6 , 2 7 , 2 8 , 2 9
8 , 1 6 , 2 4
Sensor list
2017/08/02
14:17:43
Advertisement
Table of Contents
