FUTABA 7PX User Manual page 143

Low battery protection
MC401,402CR/601,602C/850,851C:2.5V 6.0V
MC950CR/MC940,960CR 2.5V 7.5V
Same as Link software Low Bat Protection.
When the power supply voltage drops, the output current to the mo-
tor is limited and supply voltage to the receiver is ensured. When
the power supply voltage drops to the set voltage, a protection cir-
cuit operation alarm is activated and output to the motor is cut. The
protection circuit is automatically reset by recovery of the power
supply voltage
Current limiter
MC401,402CR/601,602C/850:50A 300A, INH
MC851C :50A~300A(can not INH)
MC950CR/MC940,960CR:50A~500A, INH
Same as Link software PWM frequency (at Max. load).
MAX sets the PWM frequency at maximum load at the output current limit value set by
Current Limiter.
Current limiter INH/ACT setting
MC950CR and MC940 / 960CR tap INH OR ACT by tapping the current limiter INH/ACT.
The MC851C does not have an INH(Off) settin
Current limit timer
MC401,402CR/601,602C/850,851C:0sec(OFF)240sec
MC940,960CR:0sec(OFF)~240sec (MC950CR can not)
Same as Link software Current Limit timer.
The output current can be limited up to the set time lapse from the start of running. This is
effective in preventing the motor from outputting wasted energy when the voltage is high im-
mediately after the power battery was recharged.
"Current Limiter (time)" sets the time the output current is limited. This function is disabled
when set to "0" sec.
Since the Current Limit Timer starts when
the throttle is operated to the forward side
and current is output to the motor, this func-
tion begins to operate when the motor is
run during trim adjustment, etc.
Current limiter (time)
MC401,402CR/601,602C/850,851C :50A~300A
MC940,960CR :50A~500A (MC950CR can not)
"Current Limit timer" sets the maximum
output current within the time the output
current is limited.
144
1M23N32602_7PX_E.indb 144
MC Link (ESC Link)
2017/08/02 14:17:37