Servo Installation - FUTABA 7PX User Manual

Warning
Connector Connections
Be sure the receiver, servo, battery and connectors are fully and firmly connected.
If vibration from the model causes a connector to work loose while the model is in operation, you may lose control .

Servo Installation

When you install the servos, always use the rubber grommets provided in servo hardware bags. Mount the
servos so they do not directly come in contact with the mount.
If the servo case comes in direct contact with the mount, vibration will be directly transmitted to the servo.
If this condition continues for a long time, the servo may be damaged and control will be lost.
Damper
Eyelet
Mechanical plate
When installing the servo, always install the accessory
rubber grommet and grommet flush against the servo.
Servo Throw
Operate each servo over its full stroke and be sure the linkage does not bind or is loose.
The continuous application of unreasonable force to a servo may cause damage and excessive battery drain.
A whining noise indicates that the
steering servo is improperly set.
Adjust the steering servo so that unreason-
able force is not applied to the servo by the
chassis at maximum servo travel.
34
1M23N32602_7PX_E.indb 34
Screw
Nut (as required)
A vibration-damping effect is not obtained even
if the rubber grommet and grommet are not in-
stalled correctly.
Caution!
Decide the EPA value at the
contact point.
(or)
Adjust the throttle servo so that unreasonable force is
not applied when the engine carburetor is fully open,
fully closed, and the brakes are applied fully.
If the brakes overheat while running, their ability to
function properly decreases. Before running, adjust the
suitable maximum servo travel so that unreasonable
force is not applied even when the servo travel is in-
creased while running.
2017/08/02 14:17:10