Changing Wheel Position And Modifying For Left-Hand Use; Exchange Procedure To Wheel Adaptor 32 Deg; Installing The Accessory Apa Steering Wheel Offset Adapter - FUTABA 7PX User Manual

Changing Wheel Position And Modifying For Left-hand Use

Changing the wheel position
The wheel position can be offset by using the
accessory APA wheel position offset adapter.
(See page 25 for the modifi cation method.)
Angle can be adjusted
The angle can be fi nely adjusted by adjusting the steering wheel unit installation. (See the
modifi cation method on the next page for the adjustment details.)
The operating angle of the wheel can be adjusted
The operating angle of the wheel can be changed from 34 deg to 32 deg by installing the
32 deg wheel adjuster. (See "Exchange procedure to wheel adaptor 32 deg" below for the
replacement procedure.
If you install the 32 deg wheel adapter, be sure to adjust the scale of the steering channel
accordingly by using the "Calibration Function" (page 184).

Exchange procedure to wheel adaptor 32 deg

- Obtain 2.5mm hex wrench./ Remove the battery.
1
Hold the wheel and remove the screw.
(Using a 2.5 mm hex wrench.)
2
Pull off the wheel and wheel adapter.
3
Install the steering wheel and the 32
deg wheel adapter using the screw.
(Using a 2.5 mm hex wrench.)
24
1M23N32602_7PX_E.indb 24
Modifying for left-hand use
The wheel section left and right installa-
tion direction can be reversed.
(See page 25 for the modifi cation method.)
Steering wheel
mounting screw
Wheel adapter
Wheel
2017/08/02 14:17:03