Table of Contents
Advertisement
1
(Preset position setup)
Tap the value button of the [Preset]. Value
input buttons appear on the screen. Use the
[+] and [-] buttons to set the preset position
of the throttle servo.
2
When finished, return to the Linkage menu screen by pressing the HOME button.
Dial / Trim Setting
The function select dial function can control the engine cut preset position with digital
dial or digital trim (page 66).
The throttle servo operating position (preset position) set by this setting is unrelated to
the setting of other functions. Maximum to minimum servo travel can be set. However,
the reverse function setting is enabled.
Caution
Always operate carefully before using this function.
While push switch PS1 to PS6, or trigger switch TS with preset function set is in the ON state, the servo (mo-
tor controller) is locked in the preset position and does not operate even if the throttle trigger is operated. If the
servo was operated at the wrong setting, you may lose control of the car (boat).
102
1M23N32602_7PX_E.indb
102
Engine Cut
*Shows the ON/OFF state
Adjust button
Adjust with the [+] and [-] but-
tons.
- Return to the initial value by
tapping the [reset] buttons.
Preset position
0~100
Initial value: 0
2017/08/02
14:17:29
Advertisement
Table of Contents
