FUTABA 7PX User Manual page 121

These functions allow you to apply mixing between the steering, throttle and auxiliary
channel.
Additional Functions
-When the steering or throttle channel is the master channel (channel that applies mix-
ing), trim data can be added. (Trim mode)
- The mixing mode selection. (Master mixing mode)
- The master channel mixing center point (point at which the direction changes) can be
offset. (Offset function)
Movement of the slave channel side
The movement of the master channel side will be added to the movement of the slave
channel side.
When trigger ratio was set to 100:0
When trigger ratio (page 62) is set to 100:0, brake operation stops. When the master
channel is set to throttle, mixing operates only at the " Rate A (forward) " side. It does not
operate at the " Rate B (brake) " side.
Home screen
The mixing function is assigned to aux-
iliary channels used by other mixing
cannot be used. When the number of
channels is insufficient, cancel the other
mixing.
122
1M23N32602_7PX_E.indb 122
Program, Mixing (1, 2, 3, 4, 5 )
Menu screen
Menu-1
Program, Mixing (1, 2, 3, 4, 5)
Menu-2
On the page 1, the setting screen such as the curve, mix-
ing rate adjustment screen, page 2, mixing ON / OFF etc.
is displayed.
Program. mixing
2017/08/02 14:17:33