FUTABA 7PX User Manual page 127

Lap timer function
- The Lap timer can memorize each lap time of each switch operation. (80 laps)
- The race time can be set. Switch operation after the set time by
alarm has elapsed automatically stops the timer. Pre-alarm can also be
set. The passage of time is announced by sounding of a buzzer (beeps)
each minute after starting.
-Alarm :Generates a beep at the set time.
Pre-alarm :Starts sounding the set time (second) before the alarm. (beeps)
- The first start operation can be linked with the throttle trigger.
(Lap timer operation)
- When lap timer is selected, the number of laps (LAP) and the lap memory No. (No.) and
current lap time (TIME) are displayed on the setup screen.
* LAP: Counted up each time the switch is pressed after starting. After the switch was pressed, the numbers
pause for 3 seconds. To prevent erroneous counting, switch operation is not accepted during this time
* Lap memory: The lamp memory saves the lap times of 80 laps.
* The lap time data stored in the lap memory can be checked at the lap list (page 134) screen.
Lap navigate timer function
- This function sounds a buzzer at a fixed interval after the timer
starts. Since only the buzzer can be restarted when the switch is
pressed during timer operation, this function can be used as the train-
ing run, etc. target time. (Lap navigation alarm) The passage of time
is announced by sounding of a buzzer (beeps) every minute after
starting.
- The first start operation can be linked with the throttle trigger.
- The alarm sounds (alarm/Pre-alarm) can be set separately from the
fixed interval buzzer.
- Alarm :Generates a beep at the set time (minutes).
- Pre-alarm :Alarm advance announcement sound. Sounding begins 10 seconds before the set alarm time.
- After starting, the timer is enabled and can be stopped by switch even when the display
switches to another screen.
128
1M23N32602_7PX_E.indb 128
Lap timer function
Lap navigate timer function
Timer
2017/08/02 14:17:34