FUTABA 7PX User Manual page 37

*
After set up this far is complete, when using a FASST system (R614FS/FF/FF-E) or S-
FHSS system (R2104GF, R204GF-E, etc.) receiver, go to "Receiver other than T-FHSS" on
page 39. When using a telemetry function T-FHSS SR receiver (R334SBS) and T-FHSS re-
ceiver (R304SB, etc.) , go to step.
3
Bring the transmitter and receiver within 50cm of each other (antennas do not touch) and
turn on the receiver power.
4
Touch [Link] on the transmitter T7PX screen, you will hear a chime sound and T7PX will
enter the link mode for 20 seconds. During the 20 second link mode, push the receiver side
push switch for about 2 seconds or more.
Receiver
5
During the 20 seconds link mode, press the receiver tactile switch for at least 2 seconds.
The LED blinks red and then changes to a greenish red
T7PX makes a beeping sound and the message "Link with receiver" appears on the screen,
release the receiver tactile switch. This ends reading of mutual ID and displays the memo-
rized receiver ID number on the T7PX screen. Power cycle the receiver. If the "Receiver not
found" error screen is displayed, linking failed. Check the set contents and repeat the linking
operation.
Link established
The link is completed.
38
1M23N32602_7PX_E.indb 38
T-FHSS T-FHSS SR
R334SBS
green steady light. When the
Link failed
Repeat the linking operation
2017/08/02 14:17:10