Table of Contents
Advertisement
Warning
Never plug it into an outlet having other than the indicated voltage.
Plugging the charger into the wrong outlet could result in an explosion or fi re.
Do not insert and remove the charger when your hands are wet.
It may cause an electric shock.
Always use the special charger or a quick charger for digital proportional R/C sets to charge a digital
proportional R/C set battery.
Overcharging a NiMH battery can result in burns, fi re, injuries, or loss of sight due to overheating, breakage, or electrolyte
leakage.
Caution
Do not plug the charger to the charging jack, if the battery is not connected to the transmitter.
The transmitter may be damaged.
When the charger is not in use, disconnect it from the AC outlet.
Do this to prevent accidents and to avoid overheating.
Power & Display Switch
The power switch and display switch are push switches.
When the power switch (PWR) is held down, operation starts by
transmitting radio waves. When the display switch (DSP) is held
down, the transmitter side data can be checked and set. When
the power is turned off, if the power switch or display switch is
held down, the power is turned off. If both switches are pressed
simultaneously, the power is turned off quickly.
DSP
"Display mode RF off"
is displayed
Radio waves are not
being transmitted.
1M23N32602_7PX_E.indb
19
When the power is turned off,
if the power switch or display
switch is held down, the power
is turned off. If both switches
are pressed simultaneously, the
power is turned off quickly.
It cannot operate.
When you do not run, turn OFF
Power & Display Switch
OFF
PWR
R a d i o wave s a r e
being transmitted.
It can operate.
2017/08/02
19
14:17:00
Advertisement
Table of Contents
