FUTABA 7PX User Manual page 90

- Delay
Sets the delay from brake operation to ABS operation. When set to 0%, the ABS func-
tion is activated without any delay. At 50%, the ABS function is activated after a delay of
approximately 0.7 seconds and at 100%, the ABS function is activated after a delay of ap-
proximately 1.4 seconds.
- Cycle speed
Sets the pulse speed (cycle speed). The smaller the set value, the faster the pulse cycle.
- Duty ratio
Sets the proportion of the time the brakes are applied and the time the brakes are released
by pulse operation. The ratio can be set to +3 ~ 0 ~ -3 in 7 steps.
- Trigger point
Sets the trigger point at which the ABS function begins to operate at brake operation.
When trigger ratio was set to 100:0
When trigger ratio (page 62) was set to 100:0, brake operation stops, and the servo does
not operate even if the ABS function is set.
A.B.S. function adjustment
1
(Function ON/OFF)
Tap "Brake" (ON) or (OFF) to select ON / OFF.
"OFF" :ABS function OFF
"ON" :ABS function ON
When using ABS function ON/OFF by
switch, use the switch select function (page
69) to set the switch to be used.
2
("Brake return" amount adjustment)
Tap the value button of the [Brake return]. Value input buttons
appear on the screen. Use the [+] and [-] buttons to adjust
the return amount.
"0" :No return
"50" :Return to the 50% position of the brake operation amount
"100" :Return to the neutral position.
1M23N32602_7PX_E.indb 91
Brake return
Brake return
(Amount of brake return)
A.B.S
* Displays ON/OFF of the con-
dition that ABS is working by
throttle trigger operation.
Adjustment buttons
- Adjust with the [+] and [-] but-
tons.
- Return to the initial value by
tapping the [reset] buttons.
Return amount
0 ~ 50 ~ 100
Initial value: 50
The amount of brake return var-
ies depending on the curve set-
ting of the brake etc.
2017/08/02
91
14:17:27