Changing The Neutral Position - FUTABA 2HR Instruction Manual

Change the neutral position only when large forward stroke of the throttle stick is need
when using an FET E.S.C., etc.
(The neutral position is set to the center at the factory.)
* However, when returning from the 2:1 to the 1:1 position (neutral center),
return the setting lever to the 1:1 side with the stick lever pushed to the HI
side. Other-wise, the setting lever cannot move.
① Remove the four transmitter
Throttle
Stick

Changing the Neutral Position

1 : 1
r e a r c a s e s c r e w s a n d
remove the front case.
1 : 1
③ Throttle stick setting lever is
changed.
② Move the setting lever at
the throttle stick body to the
outside.
2 : 1
Setting Lever
④ Close the front case while
being careful that the stick
levers, trim levers, power
switch, LEDs, and battery
contacts do not get caught.
And tighten the four screws.
2HR Functions
2 : 1
27