Yealink SIP-T54S Administrator's Manual page 107

(Enabled). If you change this parameter, the IP phone will reboot to make the change take
effect.
Web User Interface:
Network->Advanced->CDP->Packet Interval (1~3600s)
Phone User Interface:
Menu->Advanced (default password: admin) ->Network->CDP->Packet Interval
To configure CDP via web user interface:
Click on Network->Advanced.
1.
In the CDP block, select the desired value from the pull-down list of Active.
2.
Enter the desired time interval in the Packet Interval (1~3600s) field.
3.
Click Confirm to accept the change.
4.
A dialog box pops up to prompt that the settings will take effect after a reboot.
Click OK to reboot the phone.
5.
To configure CDP feature via phone user interface:
Press Menu->Advanced (default password: admin) ->Network->CDP->CDP Status.
1.
Press
2.
field.
Enter the priority value (1-3600s) in the Packet Interval field.
3.
Press the Save soft key to accept the change.
4.
A dialog box pops up to prompt that the settings will take effect after a reboot.
Click OK to reboot the phone.
5.
Manual Configuration for VLAN in the Wired Network
VLAN is disabled on IP phones by default. You can configure VLAN for the Internet port and PC
port manually. For CP860/CP920 IP phones, you can only configure VLAN for the Internet port
manually, because they only have Internet port. Before configuring VLAN on the IP phone, you
need to obtain the VLAN ID from your network administrator.
Parameters
or , or the Switch soft key to select the desired value from the CDP Status
Setting Up Your System
Permitted Values Default
81