Configuring Edk Feature - Yealink SIP-T54S Administrator's Manual

Macro Action
E2/CP860/CP920 IP phones)

Configuring EDK Feature

To configure EDK list, EDK prompt, EDK soft keys and custom DSS keys, you have to enable EDK
feature. By default, the EDK feature is disabled.
Yealink IP phones support displaying the softkey id or menu item id by long pressing the
Volume Up key. It is especially useful for those users who need to view the softkey id or menu
item id when configuring EDK macros.
Description
status of the BLF/BLF list key. The valid value of the
duration time ranges from 100 to 60000ms.
Can be composed of multiple combination of "color" and
"time". The status will be stuck in an infinite loop until
triggered by other macros.
Supported colors include (must be lowercase):
r (red)

ri (red; red with incoming mark for SIP-

T48G/S)
ro (red; red with outgoing mark for SIP-

T48G/S)
g (green)

gi (green; green with incoming mark for

SIP-T48G/S)
go (green; green with outgoing mark for

SIP-T48G/S)
o (off)

&L<label> (Optional.): You have to put the "&L<label>"
last in the command flow.
Example: $LEDg1000o100r300&Lidle$ means an infinite
loop for BLF/BLF list key LED status: illuminates solid
green for 1000ms, goes out for 100ms and then
illuminates solid red for 300ms. At the same time, the
label of the BLF/BLF list key is changed to "idle".
Note: The last "color" can be configured without "time",
and it means permanently displaying the last color until
triggered by other macros. This macro can be only used
for BLF/BLF list feature. For more information, refer to
Configuring BLF LED Status and BLF Key Behavior
617.
Configuring Advanced Features
on page
795