Configuring Dhcp Server; Enabling The Dhcp Service; Dhcp Interfaces - RuggedCom RuggedBackbone RX5000 User Manual

15. DHCP Server

15.2. Configuring DHCP Server

The DHCP Server menu is available under services at services/dhcpserver.
Figure 15.1. DHCP Server menu
Under services/dhcpserver, you can configure the following:
• enable the DHCP service. See
• set the interface. See
• configure subnets and pools. See
• configure shared networks. See
• configure hosts. See
• configure host-groups. See
• configure DHCP options. See
Under services/dhcpserver, you can also view a list of active DHCP leases. See
Active DHCP Leases".

15.2.1. Enabling the DHCP Service

To enable or disable the DHCP service, navigate to services/dhcpserver. On the Dynamic Host Control
Protocol (DHCP) server form, enable or disable the DHCP service.
Figure 15.2. DHCP Server form
enabled
Enables and disables the the DHCP server.

15.2.2. DHCP Interfaces

A DHCP listen interface is the interface on which DHCP listens for lease requests. You can configure
multiple DHCP interfaces.
• To view a list of DHCP listen interfaces, navigate to services/dhcpserver/interface.
ROX™ v2.2 User Guide
Section 15.2.1, "Enabling the DHCP
Section 15.2.2, "DHCP Interfaces".
Section 15.2.3, "DHCP Subnets and
Section 15.2.4, "DHCP Shared
Section 15.2.5, "DHCP Hosts".
Section 15.2.6, "DHCP
Section 15.2.8, "DHCP
141
Service".
Pools".
Networks".
Host-groups".
Options".
Section 15.2.7, "Viewing
RuggedBackbone™ RX5000