Switching The Broadcast Mode - Sony IPELA PCS-G50 Operating Instructions Manual

Switching the Broadcast Mode

At the beginning of the conference, the mode set for "Broadcast Mode" on
page 4 of the Communication Setup menu is applied. You can change the
mode during communication.
1
Press the FAR/NEAR button on the Remote Commander.
The Display Control menu appears.
2
Use the V, v, B or b button on the Remote Commander to select
"Broadcast Mode", then press the PUSH ENTER button.
Display Control
Display
Far
Split: Selects the Split mode.
Split (A Fixed): Specifies the picture of the terminal connected first to fix
in the Split (Fixed) mode.
Split (B Fixed): Specifies the picture of the terminal connected second to
fix in the Split (Fixed) mode.
Split (C Fixed): Specifies the picture of the terminal connected third to fix
in the Split (Fixed) mode.
Split (D Fixed): Specifies the picture of the terminal connected fourth to
fix in the Split (Fixed) mode.
Split (E Fixed): Specifies the picture of the terminal connected fifth to fix
in the Split (Fixed) mode.
Split (Near End Fixed): Fixes the local picture in the Split (Fixed) mode.
Voice Activate: Selects the Voice Activate mode.
Self Broadcast: Broadcasts the near end (local) party in the Broadcast
mode.
A Broadcast: Broadcasts the picture of the terminal connected first in the
Broadcast mode.
B Broadcast: Broadcasts the picture of the terminal connected second in
the Broadcast mode.
C Broadcast: Broadcasts the picture of the terminal connected third in the
Broadcast mode.
D Broadcast: Broadcasts the picture of the terminal connected fourth in
the Broadcast mode.
E Broadcast: Broadcasts the picture of the terminal connected fifth in the
Broadcast mode.
Stop Broadcast: Stops broadcasting in the Broadcast Mode.
Control Broadcast Mode
Near
Split
Camera
Using the Display Control
189