System To Standby Mode - Sony IPELA PCS-G50 Operating Instructions Manual

Setting the Video Communication System to Standby Mode
You can turn on the Video Communication System with the
Remote Commander if it is in standby mode.
1
Display the launcher menu on the monitor screen, then press the
on the Remote Commander.
The message "Power off?" appears on the monitor screen.
2
Press the B or b button on the Remote Commander to select OK, and press
the PUSH ENTER button.
You may press the @/1 button on the Remote Commander.
The Video Communication System enters standby mode and the POWER
indicator on the Communication Terminal lights in orange. The POWER
indicator on the camera goes out.
If the IR repeater is installed in a Sony TV monitor, it will go into standby
together with the Video Communication System.
Note
When the Remote Control Receiver is not in use and the Communication Terminal and
the Camera are separately installed, point the Remote Commander to the Camera for
operations.
To cancel setting the system to standby
Select "Cancel" with the B or b button on the Remote Commander, then press
the PUSH ENTER button in step 2 above.
@ 1
/ button
B/b buttons and PUSH ENTER
button
/ button on the
@ 1
POWER indicator (Not lit.)
POWER indicator (Lights orange.)
Turning the System On/Off
@ / 1 button
33