Download  Print this page

Sony IPELA PCS-G50 Manual

Video communication system ipela vc link guide.
Hide thumbs
   

Advertisement

3-993-428-11 (1)
Video
Communication
System
IPELA VC Link Guide
PCS-G50
© 2006 Sony Corporation

Advertisement

Table of Contents

   Related Manuals for sony IPELA PCS-G50

   Summary of Contents for sony IPELA PCS-G50

  • Page 1 3-993-428-11 (1) Video Communication System IPELA VC Link Guide PCS-G50 © 2006 Sony Corporation...
  • Page 2 The screen switches to the Setup menu. Notes • For details on obtaining the “Function Extension Command,” consult your Sony dealer. • If the “SIP Server Mode” setting is set to “On” on the SIP Setup menu, an error message appears, and IPELA VC Link does not activate.
  • Page 3 Set “Enable IPELA VC Link” to “On,” and enter an “IPELA VC Link Number” and “Password.” Note For details on acquiring an IPELA VC Link number and password, consult your Sony dealer. IPELA VC Link 1 /3 Enable IPELA VC Link...
  • Page 4 Starting a Multipoint Starting a Videoconference Videoconference With the The procedure is the same as that for a normal IPELA VC Link Function videoconference. For details, see “Starting a Multipoint Videoconference” in the Operating Instructions. Calling a Remote Party Details of IPELA VC Link For instructions on calling a remote party from the Direct Phone Book or Phone Book, see “Starting a Conference by Setup...
  • Page 5 Page 2/3 No display: Does not display any number identifying the system. IPELA VC Link Page 3/3 2 /3 NAT Mode NAT Address Port Number 5060 Line I/F Number Display Save Cancel NAT Mode Selects whether to use NAT mode. Auto (UPnP): Enable the UPnP function.
  • Page 6 On Screen Messages Check the following if a message appears on the display when operating the Video Communication System. Message Response Router is not supported. (No M-SEARCH A supported router could not be found. Confirm the UPnP settings for the router. response) Router is not supported.
  • Page 8 Sony Corporation Printed in Japan...

Comments to this Manuals

Symbols: 0
Latest comments: