Sony IPELA PCS-G50 Operating Instructions Manual page 183

The system begins dialing the number of the remote party with the
" " appears on the monitor screen, and the ON LINE indicator (blue) on
Dialing
the Communication Terminal blinks.
When the system connects to all the parties, the message "Meeting starts!"
appears on the screen, and the ON LINE indicator stops blinking and lights.
To call remote parties not registered in the Phone Book
Basic operations are the same as those for starting a point-to-point conference.
For details, see "To call a remote party not registered in the Phone Book" on
page 83.
1
Select "Detail Dial" in the launcher menu to open the Detail Dial menu.
2
Set up the line interface of the remote parties.
When PCSA-M3G50 H.323 MCU software (for LAN) is installed
Select "Multipoint", and enter the IP addresses of all the parties for the
multipoint videoconference in text boxes A to E.
When PCSA-M0G50 H.320 MCU software (for ISDN) is installed
Select "Multipoint", and enter the line numbers or phone numbers of all the
parties for the multipoint videoconference in text boxes A to E.
When both PCSA-M3G50 H.323 MCU software (for LAN) and PCSA-
M0G50 H.320 MCU software (for ISDN) are installed
Select "Multipoint" and a drop-down list is displayed to the right of text
boxes A to E.
When using a LAN, select "IP" from the drop-down list, and enter the IP
address.
When using ISDN, select "ISDN" from the drop-down list, and enter the
line number.
When using ISDN (Telephone), select "TEL" from the drop-down list, and
enter the telephone number.
Enter all the parties for the multipoint videoconference.
Starting a Multipoint Videoconference
marks.
183