Sony IPELA PCS-G50 Operating Instructions Manual page 65

Primary DNS
Enter a primary DNS address.
Secondary DNS
Enter a secondary DNS address.
NAT/Port Page 1/1
LAN Setup
NAT/Port
Page: 1/1
NAT Mode
NAT Address
Port Number Used
TCP Port Number
UDP Port Number
NAT Mode
Allows you to select whether you connect
the system to a local network using Network
Address Translation (NAT), which allows
one IP address to be shared by several
computers on the same LAN.
On: Enables NAT mode.
Off: Disables NAT mode.
NAT Address
Enter the IP address of a global network to
be used for NAT mode.
Port Number Used
Allows you to select whether to fix the TCP
port and UDP port numbers.
Custom: Uses the port numbers set by the
user.
Default: Uses the default port numbers:
2253-2255 as the TCP port number and
49152-49159 as the UDP port number.
TCP Port Number
When "Port Number Used" is set to
"Custom", enter the TCP port number.
UDP Port Number
When "Port Number Used" is set to
"Custom", enter the UDP port number.
For details on the port numbers used,
See "List of Port Numbers Used on the
PCS-PG50/PG50P" on page 241.
Off
. . .
Default
2253-2255
49152-49159
Save Cancel
QoS Page 1/1
LAN Setup
QoS
Page: 1/1
Hybrid
Forward Error Correction
Packet Resend Request
Adaptive Rate Control
Hybrid
Allows you to select whether to use forward
error correction, send requests to resend
packets, and use adaptive rate control
depending on the network status.
On: Forward Error Correction, Packet
Resend Request, or Adaptive Rate
Control is used automatically depending
on the network status.
Off: The three functions above are not used
automatically depending on the network
status.
Forward Error Correction
Allows you to select whether received
packets containing errors are corrected upon
reception.
On: Corrects packets.
Off: Does not correct packets.
Packet Resend Request
Allows you to select whether to request
packet to be resent when packet losses occur
during communication.
On: Requests packets to be resent.
Off: Does not request packets to be resent.
Adaptive Rate Control
Allows you to select whether to always
optimize the LAN bandwidth.
On: Always optimizes the LAN bandwidth.
Off: Does not optimize the LAN bandwidth.
Note
You can only configure "Adaptive Rate
Control" when "Packet Resend Request" is set
to "Off". When "Packet Resend Request" is set
to "On", "Adaptive Rate Control" is also
always set to "On".
Registering Local Information
On
On
On
On
Save Cancel
65