Connecting the CTE-600 Communication Transducer
Cable (supplied
with the CTE-600)
CTE-600
to an input/output
connector
To use the Communication Transducer connected to the Data Solution Box
• Set "CTE" on page 1 of the Audio Setup menu to "DSB AUX IN" (page 53).
• Set the SYSTEM SELECT switch at the bottom of the Communication
Transducer to "PCS".
Note
You cannot use two or more Communication Transducers in a room and cannot use it
together with other microphones.
For detailed information on the Communication Transducer, refer to the
Operating Instructions that come with the Communication Transducer.
to an input/output connector
to LINE
to LINE
IN
OUT
to AUX OUT
to AUX IN
PCSA-DSB1S Data Solution Box (Rear)
Connection Example Using the Data Solution Box
Interface box
(supplied with the CTE-600)
to DC 6V
AC adaptor
(supplied with
the CTE-600)
Cable (not supplied)
to a wall
outlet
151