Dr 7 Process Interfaces - Siemens SIWAREX WT241 Manual

11.10

DR 7 Process interfaces

Data record DR 7 contains the parameters for defining the properties of the available I/O
modules (digital inputs, digital outputs, analog output, serial ports).
If a port is not used, the default value can be retained.
Procedure
● Change the parameters if necessary
● Transfer the data record to the scale
Table 11- 8 Assignment of data record 7
Variable Note
Data record Contains no. of data record
number
Length Data record length information
Application Information about which application the
DR belongs to
Version Information about current data record
identifier version
Assignment Assignment of digital input .0
digital input Code 0: No command assigned
DI 0, 1, 2, 3 1 ... n: command number, is triggered at
(Page 128) a rising edge (0->1 transition), 1304
pulse sensor
Assignment of digital input .1
Code 0: No command assigned
1 ... n: command number, is triggered at
a rising edge (0->1 transition)
Assignment of digital input .2
Code 0: No command assigned
1 ... n: command number, is triggered at
a rising edge (0->1 transition)
Assignment of digital input .3
Code 0: No command assigned
1 ... n: command number, is triggered at
a rising edge (0->1 transition)
Input filter- 0: 0.2 ms
ing (hard- 1: 0.2 ms
ware 2: 0.4 ms
setting) 3: 0.8 ms
(Page 128) 4: 1.6 ms
5: 3.2 ms
6: 6.4 ms
7: 12.8 ms
Assignment Assignment of digital output .0
digital out- 100...131: Bit no. of the status flags
put DQ 0, from bytes 0 to 3 (DR 30), but inverted
1, 2, 3 33: data record 18
(Page 128) 34: S7 I/O modules
SIWAREX WT241
Manual, 05/2015, A5E36046748Aa
Type L Rw Default
USHORT 2 r 7
USHORT 2 r 64
USHORT 2 r 104
USHORT 2 r 1
USHORT 2 rw 0
USHORT 2 rw 0
USHORT 2 rw 0
USHORT 2 rw 0
USHORT 2 rw 5
USHORT 2 rw 0
Communication
11.10 DR 7 Process interfaces
Min. Max. Register
- - 1309
- - 1310
- - 1311
1 65635 1312
0 1999 1313
0 1999 1314
0 1999 1315
0 1999 1316
0 7 1317
0 0xFFFF 1318
125