Dr 4 Temporary Parameters - Siemens SIWAREX WT241 Manual

11.7

DR 4 Temporary parameters

Data record DR 4 temporarily displays the results of the calibration commands. You can
decide if you wish to apply the results and transfer them to the parameter set in DR 3. The
new calibration results become effective following importing into the parameter set. The
temporary parameters are not saved powerfail-proof.
This data record cannot be sent to the scale.
Table 11- 5 Assignment of data record 4
Variable Note
Data record num- Contains no. of data record
ber
Length Data record length information
Application Information about which appli-
cation the DR belongs to
Version identifier Information about current data
record version
Vmax. Speed (belt Determination using the
empty) "Start/Stop belt revolution
detection" commands with
empty belt
Command for importing: "Ap-
ply (nominal) speed" (85)
Speed correction if Only relevant if a sensor is not
belt loaded present, determination using
the "Start/Stop belt revolution
detection" commands with
empty belt
Command for importing: "Ap-
ply speed parameters "belt
loaded"" (86)
Belt load factor for Only relevant if a sensor is not
the speed correc- present, determination using
tion the "Start/Stop belt revolution
detection" commands with
empty belt
Command for importing: "Ap-
ply speed parameters "belt
loaded"" (86)
Impulse constant Impulses per length unit
speed sensor (length unit from belt load),
Determination using the
"Start/Stop belt revolution
detection" commands with
empty belt
Command for importing: "Ap-
ply pulse parameter" (87)
SIWAREX WT241
Manual, 05/2015, A5E36046748Aa
Type L Rw
USHORT 2 r
USHORT 2 r
USHORT 2 r
USHORT 2 r
FLOAT 4 r
FLOAT 4 r
FLOAT 4 r
LONG 4 r
Communication
11.7 DR 4 Temporary parameters
Default Min. Max.
4 - -
88 - -
104 - -
1 1 65635
0
0
0
0
Register
1200
1201
1202
1203
1204
1206
1208
1210
115