Dr 6 Limits - Siemens SIWAREX WT241 Manual

Communication

11.9 DR 6 Limits

11.9 DR 6 Limits
Various limits are parameterized in data record DR 6. The factory-set parameters
correspond to the typical settings.
Procedure
● Read the current parameters from the SIWAREX module (receive)
● Check all parameters and modify them as required
● Transfer the data record to the SIWAREX module (send)
Table 11- 7 Assignment of data record 6
Variable Note
Data record Contains no. of data record
number
Length Data record length information
Application Information about which application the
DR belongs to
Version Information about current data record
identifier version
Negative Negative range of zero adjuster referred
and positive to the originally calibrated zero point.
zero offset Specification in % of maximum belt load
in %
Positive range of zero adjuster referred
(Page 122)
to the originally calibrated zero point.
Specification in % of maximum belt load
Smallest Smallest totalized value which may be
totalized recorded with verification capability
value
(Page 122)
Minimum Min. flow rate in % of design flow rate
flow rate (for status display)
(Page 122)
Maximum Max. flow rate in % of design flow rate
flow rate (for status display)
(Page 122)
Delay for Delay for output of status display for
flow rate flow rate (in ms)
limits
(Page 122)
Minimum Min. belt speed for status display 'Mini-
belt speed mum belt speed violated' in % of design
(Page 122) speed
Maximum Max. belt speed for status display 'Max-
belt speed imum belt speed violated' in % of design
(Page 122) speed
120
Type L Rw
USHORT 2 r
USHORT 2 r
USHORT 2 r
USHORT 2 r
FLOAT 4 rw
FLOAT 4 rw
FLOAT 4 rw
FLOAT 4 rw
FLOAT 4 rw
LONG 4 rw
FLOAT 4 rw
FLOAT 4 rw
De- Min. Max.
fault
6 - -
90 - -
104 - -
1 1 65635
1 0 100
3 0 100
0 0
0 0 200
100 0 200
1 0
10 0 100
100 0 200
Manual, 05/2015, A5E36046748A
Register
1264
1265
1266
1267
1268
1270
1272
1274
1276
1278
1280
1282
SIWAREX WT241