Dr 15 Belt Angle - Siemens SIWAREX WT241 Manual

Communication

11.16 DR 15 belt angle

11.16 DR 15 belt angle
Data recorder DR 15 is used for an external specification.
Procedure
● Enter the actual inclination angle of the conveyor belt.
● Transfer the data record to the scale.
Table 11- 16 Assignment of data record 15
Variable Note
Data record num- Contains no. of data record
ber
Length Data record length information
Application Information about which appli-
cation the DR belongs to
Version identifier Information about current data
record version
Current belt angle Angle of inclination
(Page 144)
Reserve 1 Reserve
11.16.1 Current belt angle
Input of the angle is provided for belt scales where the inclination of the belt can be changed
during operation. Calculation of the current belt load is corrected by entering the current
angle.
The input is unnecessary if the inclination is always constant: the influence of the constant
angle is compensated or automatically taken into consideration during the calibration with
weights or test chain.
If the scale is automatically calibrated using the load cell parameters and if the scale is not
installed exactly horizontally, you must subsequently enter the inclination angle of the belt.
The input is made in degrees.
144
Type L Rw
USHORT 2 r
USHORT 2 r
USHORT 2 r
USHORT 2 r
FLOAT 4 rw
SHORT 2 rw
Default Min. Max.
15 - -
16 - -
104 - -
1 1 65635 1573
0 0 60
0 0 -
SIWAREX WT241
Manual, 05/2015, A5E36046748A
Register
1570
1571
1572
1574
1576