Flashforge Cura Setup

For dreamer

Table of Contents

Download this manual

Cura Setup for Flashforge Dreamer

Step 1: Launch Cura

2.1 Option 1: Settings -> Printer -> Add Printer

Option 2: On the main interface, click the Printer section, then click Add printer in the dropdown.

2.2 On the pop-up window, please find Flashforge in the left list, then fill in your Printer name on

the right. Click Add to proceed.

Table of Contents

Do you have a question about the Cura and is the answer not in the manual?

Page 1 Option 2: On the main interface, click the Printer section, then click Add printer in the dropdown. 2.2 On the pop-up window, please find Flashforge in the left list, then fill in your Printer name on the right. Click Add to proceed.
Page 2 2.3 On the Machine Settings window, kindly fill in the Printer spec as suggested in the red. Switch to Extruder 1 to confirm the extruder setting as suggested in the red. Then click Next to proceed. Printer Setting Printhead Setting X (Width) 230.0 X min...
Page 3 Extruder Start G-code M108 T0 Note: Cura sliced files are only available for printing with Dreamer’s right extruder. Step 3: Select Nozzle Size Once the printer is added, you may go to Settings -> Extruder 1 -> Nozzle Size to select your printer’s...
Page 4 Step 4: You may now create new project and start slicing Hope this helps. If you need any assistance on slicing or printing, Flashforge’s dedicated support team is only an email away. Feel free to drop us a line at...