Stack-Port - Dell PowerConnect 7000 Series Reference Manual

Default Configuration
This command has no default mode.
Command Mode
Global Configuration mode
User Guidelines
This command has no user guidelines.
Example
The following example sets the mode to Stack Global Config.
console(config)#stack
console(config-stack)#

stack-port

Use the stack-port command in Stack Configuration mode to configure Stack
ports as either Stacking ports or as Ethernet ports. This command is used to
configure CX-4 ports to be either stacking or Ethernet ports. By default, CX-4
ports are Ethernet ports.
Syntax
unit/slot/port {ethernet | stack}
stack-port tengigabitethernet
Default Configuration
By default, these ports are configured as stacking ports.
Command Mode
Stack Configuration mode
1633
System Management Commands