Test The Ipv4 Or Ipv6 Network Configuration - Oracle X7-2 Installation Manual

Test the IPv4 or IPv6 Network Configuration

Note -
properties are set to enabled. By default, Oracle ILOM is factory-configured with network
settings enabled for a dual stack (IPv4 and IPv6) network connection. If the IPv4 State property
is enabled (SP/network state=enabled), and the IPv6 State property is disabled (SP/network
state=disabled), Oracle ILOM supports an IPv4-only network connection.
d.
Note -
changes. To log back in to Oracle ILOM, use the newly assigned service processor IP address.
Test the IPv4 or IPv6 Network Configuration
Use either the Oracle ILOM web interface or CLI to test the IPv4 or IPv6 network
configuration.
From the Oracle ILOM web interface:
■
a.
90 Oracle Servers X7-2 and X7-2L Installation Guide • October 2017
set /SP/network/ipv6 state=enabled|disabled pending_static_ipaddress=
value/subnet_mask_value pending_static_ipgatewayaddress=value
A dual-stack network connection is enabled when both the IPv4 and IPv6 State
To commit the IPv4 and IPv6 pending network changes in Oracle ILOM,
type:
set /SP/network commitpending=true
All user sessions on the SP are terminated upon committing the IP network property
Click ILOM Administration → Connectivity → Network.