Test The Ipv4 Or Ipv6 Network Configuration - Oracle X5-2 Installation Manual

set /SP/network/ipv6 state=enabled|disabled pending_static_ipaddress=
value/subnet_mask_value pending_static_ipgatewayaddress=value
A dual-stack network connection is enabled when both the IPv4 and IPv6 State
Note -
properties are set to enabled. By default, Oracle ILOM is factory-configured with network
settings enabled for a dual stack (IPv4 and IPv6) network connection. If the IPv4 State property
is enabled (
/SP/network state=enabled
), Oracle ILOM will support an IPv4-only network connection.
ipv6 state=disabled
To commit the IPv4 and IPv6 pending network changes in Oracle ILOM,
d.
type:
set /SP/network commitpending=true
All user sessions on the SP are terminated upon committing the IP network property
Note -
changes. To log back in to Oracle ILOM, use the newly assigned service processor IP address.

Test the IPv4 or IPv6 Network Configuration

Use either the Oracle ILOM web interface or CLI to test the IPv4 or IPv6 network
configuration.
From the Oracle ILOM web interface, perform these steps:
■
a. From the ILOM Administration → Connectivity screen, click the Tools
button at the bottom of the screen.
Test the IPv4 or IPv6 Network Configuration
) and the IPv6 State property is disabled (
/sp/network/
Connecting to Oracle ILOM 91